Détail de la notice
Titre du Document
Belt abrader impact abrasion testing of leathers and fabrics used in motorcycle riders' clothing
Auteur(s)
WOODS Roderick I.
Résumé
A belt abrasion tester is described. It consists of an electric motor which drives an OP 60 aluminium oxide grit belt at 8 m/s. The upper horizontal run of the belt is supported by a 25 mm thick steel plate. The sample isfixed to a rigid horizontal pendulum arm pivoted two metres from the sample. The arm can be raised so that the sample is up to 1.5 m above the belt surface before it is released to fall onto the moving belt. The sample face that is abraded is 50 mm in diameter. The static force between the sample and the belt is 49 N or 25 kPa. Two drop heights are normally used, 1.0 m to simulate abrasion in the initial impact and sliding phase and 50 mm to simulate only the sliding phase of an accident. The time to abrade a hole in the sample is measured using two trigger wires, one in front of the sample and one behind. These are connected via low-voltage relays to an electronic timer. Abrasion times of leathers and fabrics are generally 0.2-10 s. Relative abrasion resistance is calculated by reference to the abrasion time of a standard cotton canvas.
Editeur
American Society for Testing and Materials
Identifiant
ISSN : 0066-0558 CODEN : ASTTA8
Source
ASTM special technical publication A. 1996, n° 1237, pp. 57-69 [13 pages]
Langue
Anglais
Pour les membres de la communauté du CNRS, ce document est autorisé à la reproduction à titre gratuit.
Pour les membres des communautés hors CNRS, la reproduction de ce document à titre onéreux sera fournie sous réserve d’autorisation du Centre Français d’exploitation du droit de Copie.

Pour bénéficier de nos services (strictement destinés aux membres de la communauté CNRS (Centre National de la Recherche Scientifique), de l'ESR français (Enseignement Supérieur et Recherche), et du secteur public français & étranger) :